Baylorr BAY-HFV1 High Frequency Concrete Vibrator Converter

Product Description

The Baylorr BAY-HFV1 is a compact high-frequency concrete vibrator converter rated at 2.5 kW, weighing just 4 kg and operating on 380V three-phase supply. Built-in overheat protection and residual current protection are fitted as standard, and the unit is constructed to withstand working conditions on an active site. Weight is the specification that changes how this drive unit is used. At 4 kg it is carried one-handed and repositioned by the operator as the pour progresses, rather than set down in one place with the shaft dragged to reach the work. On a large slab or a sequence of columns, that mobility means the vibrator follows the concrete instead of the operator fighting the shaft to reach it — which in practice is the difference between consistent compaction across the whole pour and thorough compaction near the unit with progressively less at the extremities. High-frequency vibration acts on the mortar fraction of the mix as well as the coarse aggregate, producing denser concrete and a cleaner struck face with fewer blowholes. That is particularly relevant on fair-faced and architectural concrete where the surface is the finish, and on heavily reinforced sections where air trapped against the formwork face has nowhere to escape without effective vibration. The protection circuitry addresses the two ways these units typically fail on site. Overheat protection prevents motor burnout during extended continuous running — the normal condition during a large pour, when the vibrator does not stop for hours. Residual current protection guards against earth leakage, a genuine hazard with electrical equipment used in standing water and wet concrete. Both are standard here rather than optional extras. The HFV1 is used with a compatible flexible shaft and needle for compacting concrete in columns, walls, slabs and footings on commercial and infrastructure projects across the UAE. Shafts and needles are available separately as BAY-VIBS in 4m and 6m lengths with diameters from 25mm to 65mm. Where multiple heads are needed on large pours, the Baylorr BAY-HFV3 converter runs three vibrator heads simultaneously at up to 12,000 rpm. For single-phase sites, the BAY-ECVIB2.3 runs 17,000 rpm on 220V, and the BAY-CV-EY20 petrol vibrator works independently of any power supply. AMACO supplies this high-frequency concrete vibrator converter across the UAE from our workshop at Al Jurf Industrial Area 2, Ajman, delivering to Dubai, Sharjah, Abu Dhabi and the Northern Emirates. Our in-house service department covers motor rewinding, electrical and electronic repair and shaft service, with spare parts and annual maintenance contracts available. Contact AMACO on WhatsApp or by phone for pricing and specifications.